Beginnings — it started out easy enough but that soon changed! I decided to see if I could construct a hexagon box that had a hinged lid. Why, just because I’d never done it or see it done! I wanted a better place to keep my Lie-Nielsen spokeshave than the cardboard box it came in. Since I had some Poplar in my shop decided to use that. Started by cutting 6 pieces at 30° and assembled them using packing tape, even book matched them– easy ’nuff!!

Now that I had a hexagon cylinder it needed the end pieces. Used a scrap of MDF to play with the sizing to match the outside of the hexagon. Once the miter saw was set with a stop block and the MDF fit well I cut the Poplar. The blade angel is 30°.

I’m a tails first dovetailer and this took a bit of thinking and planning ahead. The first step was scribing the thickness of the box on both sides of the end pieces. The tails are at the and marked off with a pencil. Removal of the waste began by first deepening the scribed marks with a chisel. After cutting closely to the line those deeper lines made it easier to chop the shoulders square. Transferring to the hexagon began by scribing the thickness of the end pieces all around, both inside and outside of the hexagon. Then the end piece was positioned and the tails were transferred to the hexagon. Not much room to move a dovetail saw but that was the easier part. The waste can only be removed from the outside of the hexagon so I got creative in how to hold the hexagon. At this point, I think a slideshow will illustrate better than anything I write!

Once the box was glued up, I separated the lid on the bandsaw, I correctly assumed that cutting it would change the size so the lid was a bit smaller than the box. Another unforeseen problem is the the screws for the hinges were too long since they sit on a 30° angel — cut them shorter so there’s not a lot of purchase with them. I had a small piece of curly Spanish Cedar so used that for a lid lift and also the French fit insert to hold the spokeshave. Sorry, didn’t take any pictures of that process but it’s secured inside of the hexagon with silicone seal. The hinges and the lid lift are mortised in, quite different cutting a mortise on an angled piece of wood!

All things considered, this was an interesting challenge and glad I took it on. I enjoy these types of projects, let me know if you too decide to try making one of these. Here’s a short video I posted to YouTube of the finished project, enjoy — John.